Bridge Stp-Port Spanning-Disabled; Show Bridge - Hirschmann BAT54 Installation Manual

7
Command Line Interface

bridge stp-port spanning-disabled

This command disables the Spanning Tree Protocol for the specified interface. Use
the no form to reenable the Spanning Tree Protocol for the specified interface.
Syntax
bridge stp-port spanning-disabled <port>
no bridge stp-port spanning-disabled <port>
port - Specifies the port number on the wireless bridge. (Range: 0,
Ethernet interface; 1-16 wireless interface)
Default Setting
Enabled
Command Mode
Global Configuration
Example
This example disables the Spanning Tree Protocol for port 5.
DUAL OUTDOOR(config)#bridge stp-port spanning-disabled 5
DUAL OUTDOOR(config)#

show bridge

This command displays aging time and spanning tree settings for the Ethernet and
wireless interfaces.
Syntax
show bridge
Command Mode
Exec
7-52