Address Table Commands; Mac-Address-Table Static; Table 4-55 Address Table Commands - Edge-Core ES3510 Management Manual

Address Table Commands

These commands are used to configure the address table for filtering specified
addresses, displaying current entries, clearing the table, or setting the aging time.
Command

mac-address-table static

clear mac-address-table
dynamic
show mac-address-table
mac-address-table
aging-time
show mac-address-table
aging-time
mac-address-table static
This command maps a static address to a destination port in a VLAN. Use the no
form to remove an address.
Syntax
mac-address-table static mac-address interface interface
vlan vlan-id [action]
no mac-address-table static mac-address vlan vlan-id
• mac-address - MAC address.
• interface
• ethernet unit/port
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-10)
• port-channel channel-id (Range: 1-5)
• vlan-id - VLAN ID (Range: 1-4094)
• action -
- delete-on-reset - Assignment lasts until the switch is reset.
- permanent - Assignment is permanent.
Default Setting
No static addresses are defined. The default mode is permanent.
Command Mode
Global Configuration
Table 4-55 Address Table Commands
Function
Maps a static address to a port in a VLAN
Removes any learned entries from the forwarding database PE
Displays entries in the bridge-forwarding database
Sets the aging time of the address table
Shows the aging time for the address table
Address Table Commands
Mode
GC
PE
GC
PE
4
Page
4-175
4-176
4-176
4-177
4-178
4-175