PPP
E I
O
NTERMEDIATE
pppoe
intermediate-agent
TELNET-Client:
Start IP address
-----------------------------------------------
1. 192.168.1.19
2. 192.168.1.25
Console#
A
GENT
This section describes commands used to configure the PPPoE Intermediate
Agent (PPPoE IA) relay parameters required for passing authentication
messages between a client and broadband remote access servers.
Table 84: PPPoE Intermediate Agent Commands
Command
Function
pppoe
Enables the PPPoE IA globally on the switch
intermediate-agent
pppoe
Sets the access node identifier and generic error
intermediate-agent
message for the switch
format-type
pppoe
Enables the PPPoE IA on an interface
intermediate-agent port-
enable
pppoe
Sets the circuit-id or remote-id for an interface
intermediate-agent port-
format-type
pppoe
Sets the trust mode for an interface
intermediate-agent trust
pppoe
Enables the stripping of vendor tags from PPPoE
intermediate-agent
Discovery packets sent from a PPPoE server
vendor-tag strip
clear pppoe intermediate-
Clears PPPoE IA statistics
agent statistics
show pppoe
Displays PPPoE IA configuration settings
intermediate-agent info
show pppoe
Displays PPPoE IA statistics
intermediate-agent
statistics
This command enables the PPPoE Intermediate Agent globally on the
switch. Use the no form to disable this feature.
S
YNTAX
[no] pppoe intermediate-agent
D
S
EFAULT
ETTING
Disabled
– 865 –
C
24
HAPTER
End IP address
192.168.1.19
192.168.1.30
| Authentication Commands
PPPoE Intermediate Agent
Mode
GC
GC
IC
IC
IC
IC
PE
PE
PE