Adj 12.5 Booklet Fold Position - Xerox Phaser 7760 Service Manual

2. Adjusting the Booklet skew (Figure
a. Open the Front Door and slide out the Booklet Maker.
b. Loosen one screw.
c. For A-type skew, move the End Guide to the left. For B-type skew, move the End
Guide to the Right.
Figure 3 Adjusting the Fold Skew
3. Set machine up according to instructions in
- 2 until the Fold Skew setup meets specification or customer request.
4. After adjustment is done, go to ADJ 12.5
Revised
Phaser 7760 Color Laser Printer
3).
Table 2 and run a sample job. Repeat steps 1
Booklet Fold Position.

ADJ 12.5 Booklet Fold Position

Parts List on PL 21.15
Purpose
To set up the Booklet Maker so that the fold is in the center of the booklet. Several setups are
needed depending on paper size, set size, unstapled or stapled sets.
Check
1. Ensure the trays used are correctly programmed.
2. Ensure the Fold Skew is within specification
3. Set up the machine according to instructions in
in Customer mode. Label each booklet.
Select Paper
Job # Supply Select Booklet Creation Mode
1 11 x 17 / A3 SEF Booklet Layout, 2 sided originals / Booklet Fold Only 1 sheet
2 8.5 x 11 / A4 SEF Booklet Layout, 2 sided originals / Booklet Fold Only 1 sheet
3 11 x 17 / A3 SEF Booklet Layout, 2 sided originals / Booklet Fold Only 2 sheets
4 11 x 17 / A3 SEF Booklet Layout, 2 sided originals / Booklet Fold Only 5 sheets
5 11 x 17 / A3 SEF Booklet Layout, 2 sided originals / Booklet Fold and
Staple
6 8.5 x 11 / A4 SEF Booklet Layout, 2 sided originals / Booklet Fold and
Staple
January 2010
4-113
(ADJ 12.4).
Table 1 and run 1 set of each Booklet job
Table 1 Booklet Jobs
Repairs and Adjustments
ADJ 12.4, ADJ 12.5
Booklet
Size
2 sheets
2 sheets