Rep 1.3 Coupler Cover; Rep 1.4 Lh Cover; Rep 1.5 Output Tray Assembly - Xerox Telecopier 7017 Technical Reference Manual

REP 1.3 Coupler Cover

Parts List on PL 1.2
Removal
1. Remove power cord.
2. Remove document catch tray assembly
(REP 1.1).
3. USO: Remove coupler cover.
a. Disconnect handset cord from the left
side of terminal.
b. Disconnect telephone line cord from
the rear of terminal.
c. Remove the screw securing coupler
cover.
d. Slide coupler cover towards the rear
until it stops, then rotate bottom
edge towards the left and down to
remove.
Replacement
1. Align upper locking tab on coupler cover
with the rear of cutout on LH cover.
2. Reinstall in reverse order.
REP 1.3, 1.4, 1.5
4

REP 1.4 LH Cover

Parts List on PL 1.2
Removal
1. Remove power cord.
2. Remove document catch tray assembly
(REP 1.1).
3. Remove coupler cover (REP 1.3).
4. Open printer.
5. Open and secure scanner.
WARNING
Do not bump the scanner after it is secured.
The scan support assembly will release and
cause the upper scan assembly to pinch you.
6. Remove LH cover.
a. Release two latches from the base
plate.
b. Remove the two screws securing the
LH cover to the LH frame.
c. Pull LH cover towards the left to clear
the upper scan cover and the base
plate, then pull it straight up to clear
speaker assembly.
Replacement
Reinstall in reverse order.
6/88
4-4
www.printcopy.info

REP 1.5 Output Tray Assembly

Parts List on PL 1.1
Removal
1. Remove document catch tray assembly
(REP 1.1).
2. Remove output tray assembly.
a. Lift output tray assembly straight up
until top front ridge touches base
frame.
b. Rotate rear of output tray assembly
forward, then slide
assembly backward to remove.
Replacement
1. Align front lip of output tray assembly
with opening in rear of base frame.
2. Position output tray assembly parallel to
input tray extension.
3. Insert front of output tray assembly fully
into opening.
4. Rotate rear of output tray assembly
forward while pressing down on front of
output tray assembly until output tray
assembly slips into a secured position.
5. Press output tray assembly down to
ensure it is fully seated.
6. Reinstall document catch tray assembly
(REP 1.1).
Telecopier 7017 / 7017SF
output tray