Radius Source-Interface; Radius Server Timeout - Ubiquiti EDGESWITCH ES-24-250W Command Reference Manual

EdgeSwitch CLI Command Reference
Default
4
radius server retransmit retries
Format
Mode Global Config
Parameter
retries
no radius server retransmit
no
The form of this command sets the value of this global parameter to the default value .
no radius server retransmit
Format
Mode Global Config

radius source-interface

Use this command to specify the physical or logical interface to use as the RADIUS client source interface (source
IP address) . If configured, the address of
between the RADIUS server and the RADIUS client . The selected
filling the IP header of RADIUS management protocol packets . This allows security devices (firewalls) to identify
the source packets coming from the specific switch .
source-interface
If a
used as the source address . If the configured interface is down, the RADIUS client falls back to its default behavior .
radius source-interface {slot/port | loopback loopback-id | vlan vlan-id}
Format
Mode
Global Config
Parameter
slot/port
loopback-id
vlan-id
no radius source-interface
Use this command to reset the RADIUS source interface to the default settings .
no radius source-interface
Format
Mode Global Config

radius server timeout

This command configures the RADIUS client global parameter that specifies the timeout value (in seconds) after
which a request must be retransmitted to the RADIUS server if no response is received . The timeout value is an
integer in the range of 1 to 30 .
Default 5
radius server timeout seconds
Format
Mode
Global Config
Parameter
seconds
Ubiquiti Networks, Inc.
Definition
The maximum number of transmission attempts in the range of 1 to 15.
source-interface
is not specified, the primary IP address of the originating (outbound) interface is
Definition
The unit identifier assigned to the switch.
Configures the loopback interface. The range of the loopback ID is 0 to 7.
Configures the VLAN interface to use as the source IP address. The range of the VLAN ID is 1 to 4093.
Definition
Timeout value in seconds in the range 1–30.
Management Commands
is used for all RADIUS communications
source-interface
IP address is used for
85