Gvrp Commands; Set Gvrp Adminmode; Set Gvrp Interfacemode; Show Gvrp Configuration - Ubiquiti EDGESWITCH ES-24-250W Command Reference Manual

EdgeSwitch CLI Command Reference

GVRP Commands

This section describes the commands you use to configure and view GARP VLAN Registration Protocol (GVRP)
information . GVRP-enabled switches exchange VLAN configuration information, which allows GVRP to provide
dynamic VLAN creation on trunk ports and automatic VLAN pruning .
Note: If GVRP is disabled, the system does not forward GVRP messages .

set gvrp adminmode

This command enables GVRP on the system .
Default disabled
set gvrp adminmode
Format
Mode Privileged EXEC
no set gvrp adminmode
This command disables GVRP .
no set gvrp adminmode
Format
Mode Privileged EXEC

set gvrp interfacemode

This command enables GVRP on a single port (Interface Config mode), a range of ports (Interface Range mode),
or all ports (Global Config mode) .
Default disabled
set gvrp interfacemode
Format
Mode • Interface Config
• Interface Range
• Global Config
no set gvrp interfacemode
This command disables GVRP on a single port (Interface Config mode) or all ports (Global Config mode) . If GVRP
is disabled, Join Time, Leave Time and Leave All Time have no effect .
no set gvrp interfacemode
Format
Mode • Interface Config
• Global Config

show gvrp configuration

This command displays Generic Attributes Registration Protocol (GARP) information for one or all interfaces .
show gvrp configuration {slot/port | all}
Format
Mode • Privileged EXEC
• User EXEC
Term
Interface
Join Timer
Ubiquiti Networks, Inc.
Definition
Interface in slot/port format.
The interval between the transmission of GARP PDUs registering (or reregistering) membership for an
attribute. Current attributes are a VLAN or multicast group. There is an instance of this timer on a per-
Port, per-GARP participant basis. Permissible values are 10 to 100 centiseconds (0.1 to 1.0 seconds).
The factory default is 20 centiseconds (0.2 seconds). The finest granularity of specification is one
centisecond (0.01 seconds).
Switching Commands
233