Dhcp And Bootp Relay Commands; Bootpdhcprelay Cidoptmode; Bootpdhcprelay Maxhopcount; Bootpdhcprelay Minwaittime - Ubiquiti EDGESWITCH ES-24-250W Command Reference Manual

EdgeSwitch CLI Command Reference

DHCP and BOOTP Relay Commands

This section describes the commands you use to configure BootP/DHCP Relay on the switch . A DHCP relay agent
operates at Layer 3 and forwards DHCP requests and replies between clients and servers when they are not on
the same physical subnet .

bootpdhcprelay cidoptmode

This command enables the circuit ID option mode for BootP/DHCP Relay on the system .
Default disabled
bootpdhcprelay cidoptmode
Format
Mode Global Config
no bootpdhcprelay cidoptmode
This command disables the circuit ID option mode for BootP/DHCP Relay on the system .
no bootpdhcprelay cidoptmode
Format
Mode Global Config

bootpdhcprelay maxhopcount

This command configures the maximum allowable relay agent hops for BootP/DHCP Relay on the system . The
maxhopcount
parameter has a range of 1 to 16 .
Default
4
bootpdhcprelay maxhopcount 1-16
Format
Mode Global Config
no bootpdhcprelay maxhopcount
This command configures the default maximum allowable relay agent hops for BootP/DHCP Relay on the system .
no bootpdhcprelay maxhopcount
Format
Mode Global Config

bootpdhcprelay minwaittime

This command configures the minimum wait time for BootP/DHCP Relay on the system . When the BOOTP relay
agent receives a BOOTREQUEST message, it may use the request's
field as a factor in deciding whether to relay the request or not . The parameter has a range of 0 to 100 seconds .
Default 0
bootpdhcprelay minwaittime 0-100
Format
Mode Global Config
no bootpdhcprelay minwaittime
This command configures the default minimum wait time in seconds for BootP/DHCP Relay on the system .
no bootpdhcprelay minwaittime
Format
Mode Global Config
Ubiquiti Networks, Inc.
Routing Commands
seconds-since-client-began-booting
349