Lldp (802.1Ab) Commands; Lldp Transmit; Lldp Receive; Lldp Timers - Ubiquiti EDGESWITCH ES-24-250W Command Reference Manual

Hide thumbs Also See for EDGESWITCH ES-24-250W:
Table of Contents

Advertisement

EdgeSwitch CLI Command Reference

LLDP (802.1AB) Commands

This section describes the command you use to configure Link Layer Discovery Protocol (LLDP), which is defined
in the IEEE 802 .1AB specification . LLDP allows stations on an 802 LAN to advertise major capabilities and physical
descriptions . The advertisements allow a network management system (NMS) to access and display this information .

lldp transmit

Use this command to enable the LLDP advertise capability on an interface or a range of interfaces .
Default
disabled
lldp transmit
Format
Mode
Interface Config
no lldp transmit
Use this command to return the local data transmission capability to the default .
no lldp transmit
Format
Mode
Interface Config

lldp receive

Use this command to enable the LLDP receive capability on an interface or a range of interfaces .
Default
disabled
lldp receive
Format
Mode
Interface Config
no lldp receive
Use this command to return the reception of LLDPDUs to the default value .
no lldp receive
Format
Mode
Interface Config

lldp timers

Use this command to set the timing parameters for local data transmission on ports enabled for LLDP . The
interval-seconds
determines the number of seconds to wait between transmitting local data LLDPDUs .
The range is 1-32768 seconds . The
local data LLDPDUs . The multiplier range is 2-10 . The
and the range is 1-10 seconds .
• interval: 30 seconds
Default
• hold: 4
• reinit: 2 seconds
lldp timers [interval interval-seconds] [hold hold-value] [reinit reinit-seconds]
Format
Mode
Global Config
no lldp timers
Use this command to return any or all timing parameters for local data transmission on ports enabled for LLDP to
the default values .
no lldp timers [interval] [hold] [reinit]
Format
Mode
Global Config
Ubiquiti Networks, Inc.
hold-value
is the multiplier on the transmit interval that sets the TTL in
reinit-seconds
Switching Commands
is the delay before reinitialization,
294

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Edgeswitch es-24-500wEdgeswitch es-48-750wEdgeswitch es-48-500wEdgeswitch es-24-250w

Table of Contents