Ip Routing Commands; Routing; Ip Routing; Ip Address - Ubiquiti EDGESWITCH ES-24-250W Command Reference Manual

EdgeSwitch CLI Command Reference

IP Routing Commands

This section describes the commands you use to enable and configure IP routing on the switch .

routing

This command enables IPv4 and IPv6 routing for an interface or range of interfaces . You can view the current
value for this function with the
Default disabled
routing
Format
Mode
Interface Config
no routing
This command disables routing for an interface . You can view the current value for this function with the
ip brief
command . The value is labeled as
no routing
Format
Mode Interface Config

ip routing

This command enables the IP Router Admin Mode for the master switch .
ip routing
Format
Mode Global Config
no ip routing
This command disables the IP Router Admin Mode for the master switch .
no ip routing
Format
Mode Global Config

ip address

This command configures an IP address on an interface or range of interfaces . You can also use this command to
configure one or more secondary IP addresses on the interface . The command supports RFC 3021 and accepts
using 31-bit prefixes on IPv4 point-to-point links . This command adds the label IP address in the command
"show ip interface" on page 326 .
Note: The 31-bit subnet mask is only supported on routing interfaces . The feature is not supported on
network port and service port interfaces because the EdgeSwitch acts as a host, not a router, on these
management interfaces .
ip address ipaddr {subnetmask | /masklen} [secondary]
Format
Mode Interface Config
Parameter
ipaddr
subnetmask
masklen
Example: The following example of the command shows the configuration of the subnet mask with an IP
address in the dotted decimal format on interface 4/1 .
(UBNT EdgeSwitch) #config
(UBNT EdgeSwitch) (Config)#interface 4/1
(UBNT EdgeSwitch) (Interface 4/1)#ip address 192.168.10.1 255.255.255.254
Ubiquiti Networks, Inc.
show ip brief
command . The value is labeled as
Routing
Description
The IP address of the interface.
A 4-digit dotted-decimal number which represents the subnet mask of the interface.
Implements RFC 3021. Using the "/" notation of the subnet mask, this is an integer that indicates the
length of the subnet mask. Range is 5 to 32 bits.
Mode .
Routing Commands
Routing Mode .
show
320