EdgeSwitch CLI Command Reference
no debug igmpsnooping receive
This command disables tracing of received IGMP Snooping packets .
no debug igmpsnooping receive
Format
Mode
Privileged EXEC
debug ip acl
Use this command to enable debug of IP Protocol packets matching the ACL criteria .
Default
disabled
debug ip acl acl-number
Format
Mode
Privileged EXEC
no debug ip acl
Use this command to disable debug of IP Protocol packets matching the ACL criteria .
no debug ip acl acl-number
Format
Mode
Privileged EXEC
debug ipv6 dhcp
This command displays "debug" information about DHCPv6 client activities and traces DHCPv6 packets to and
from the local DHCPv6 client .
Default
disabled
debug ipv6 dhcp
Format
Mode
Privileged EXEC
no debug ipv6 dhcp
This command disables the display of "debug" trace output for DHCPv6 client activity .
no debug ipv6 dhcp
Format
Mode
Privileged EXEC
debug lacp packet
This command enables tracing of LACP packets received and transmitted by the switch .
Default
disabled
debug lacp packet
Format
Mode
Privileged EXEC
A sample output of the trace message is shown below .
<15> JAN 01 14:04:51 10.254.24.31-1 DOT3AD[183697744]: dot3ad_debug.c(385) 58 %%
Pkt TX - Intf: 0/1(1), Type: LACP, Sys: 00:11:88:14:62:e1, State: 0x47, Key: 0x36
no debug lacp packet
This command disables tracing of LACP packets .
no debug lacp packet
Format
Mode
Privileged EXEC
Ubiquiti Networks, Inc.
Utility Commands
171