Show Trapflags - Ubiquiti EDGESWITCH ES-24-250W Command Reference Manual

EdgeSwitch CLI Command Reference

show trapflags

This command displays trap conditions . The command's display shows all the enabled OSPFv2 and OSPFv3
trapflags . Configure which traps the switch should generate by enabling or disabling the trap condition . If a trap
condition is enabled and the condition is detected, the SNMP agent on the switch sends the trap to all enabled
trap receivers . You do not have to reset the switch to implement the changes . Cold and warm start traps are
always generated and cannot be disabled .
show trapflags
Format
Mode Privileged EXEC
Term
Authentication Flag
Link Up/Down Flag
Multiple Users Flag
Spanning Tree Flag
Ubiquiti Networks, Inc.
Definition
Can be enabled or disabled. The factory default is enabled. Indicates whether authentication failure
traps will be sent.
Can be enabled or disabled. The factory default is enabled. Indicates whether link status traps will
be sent.
Can be enabled or disabled. The factory default is enabled. Indicates whether a trap will be sent when
the same user ID is logged into the switch more than once at the same time (either through Telnet or
the serial port).
Can be enabled or disabled. The factory default is enabled. Indicates whether spanning tree traps
are sent.
Management Commands
81