Show Dhcp Lease; Show Ip Brief - Ubiquiti EDGESWITCH ES-24-250W Command Reference Manual

EdgeSwitch CLI Command Reference

show dhcp lease

This command displays a list of IPv4 addresses currently leased from a DHCP server on a specific in-band
interface or all in-band interfaces . This command does not apply to service or network ports .
show dhcp lease [interface slot/port]
Format
Mode Privileged EXEC
Term
IP address, Subnet mask
DHCP Lease server
State
DHCP transaction ID
Lease
Renewal
Rebind
Retry count

show ip brief

This command displays all the summary information of the IP, including the ICMP rate limit configuration and the
global ICMP Redirect configuration .
show ip brief
Format
Modes
• Privileged EXEC
• User EXEC
Term
Default Time to Live
Routing Mode
Maximum Next Hops
Maximum Routes
ICMP Rate Limit Interval
ICMP Rate Limit Burst Size
ICMP Echo Replies
ICMP Redirects
Example: The following shows example CLI display output for the command .
(UBNT EdgeSwitch) #show ip brief
Default Time to Live........................... 64
Routing Mode................................... Disabled
Maximum Next Hops.............................. 4
Maximum Routes................................. 128
ICMP Rate Limit Interval....................... 1000 msec
ICMP Rate Limit Burst Size..................... 100 messages
ICMP Echo Replies.............................. Enabled
ICMP Redirects................................. Enabled
Ubiquiti Networks, Inc.
Definition
The IP address and network mask leased from the DHCP server.
The IPv4 address of the DHCP server that leased the address.
State of the DHCPv4 Client on this interface.
The transaction ID of the DHCPv4 Client.
The time (in seconds) that the IP address was leased by the server.
The time (in seconds) when the next DHCP renew Request is sent by DHCPv4 Client to renew the
leased IP address.
The time (in seconds) when the DHCP Rebind process starts.
Number of times the DHCPv4 client sends a DHCP REQUEST message before the server responds.
Definition
The computed TTL (Time to Live) of forwarding a packet from the local router to the final destination.
Shows whether the routing mode is enabled or disabled.
The maximum number of next hops the packet can travel.
The maximum number of routes the packet can travel.
Shows how often the token bucket is initialized with burst-size tokens. Burst-interval is from 0 to
2147483647 milliseconds. The default burst-interval is 1000 msec.
Shows the number of ICMPv4 error messages that can be sent during one burst-interval. The range is
from 1 to 200 messages. The default value is 100 messages.
Shows whether ICMP Echo Replies are enabled or disabled.
Shows whether ICMP Redirects are enabled or disabled.
Routing Commands
325