Match Src Port; Match Vlan; Match Secondary-Vlan - Ubiquiti EDGESWITCH ES-24-250W Command Reference Manual

EdgeSwitch CLI Command Reference
To specify the match condition as a numeric value, one Layer-4 port number is required . The port number is an
integer from 0 to 65535 . Use the
Default none
match [not] srcl4port {portkey | 0-65535}
Format
Mode Class-Map Config

match src port

This command adds a match condition for a range of Layer-4 source ports . If an interface receives traffic that
is within the configured range of Layer-4 source ports, then only the appiq class is in effect . The
parameter specifies a single source port .
Default none
match src port {portstart-portend | portvalue}
Format
Mode Class-Map Config

match vlan

This command adds to the specified class definition a match condition based on the value of the Layer-2 VLAN
Identifier field (the only tag in a single tagged packet or the first or outer tag of a double VLAN tagged packet) .
The VLAN ID is an integer from 0-4093 . Use the
Default none
match [not] vlan 0-4093
Format
Mode Class-Map Config

match secondary-vlan

This command adds to the specified class definition a match condition based on the value of the Layer-2
secondary VLAN Identifier field (the inner 802 .1Q tag of a double VLAN-tagged packet) . The secondary VLAN ID is
an integer from 0-4093 . Use the
Default none
match [not] secondary-vlan 0-4093
Format
Mode Class-Map Config
Ubiquiti Networks, Inc.
not
option to negate the match condition .
not
option to negate the match condition .
not
option to negate the match condition .
Quality of Service Commands
portvalue
378