No Access-List; Ip Access-List; Ip Access-List Rename - Ubiquiti EDGESWITCH ES-24-250W Command Reference Manual

EdgeSwitch CLI Command Reference
time-range time-
range-name
assign-queue queue-id
{mirror | redirect}
slot/port
rate-limit rate
burst-size

no access-list

This command deletes an IP ACL that is identified by the parameter accesslistnumber from the system . The range
for 1-99 for standard access lists and 100-199 for extended access lists .
accesslistnumber
no access-list accesslistnumber
•
Format
Mode Global Config

ip access-list

This command creates an extended IP Access Control List (ACL) identified by name, consisting of classification
fields defined for the IP header of an IPv4 frame . The
from 1 to 31 characters uniquely identifying the IP access list . The rate-limit attribute configures the committed
rate and the committed burst size .
If an IP ACL by this name already exists, this command enters IPv4-Access_List config mode to allow updating
the existing IP ACL .
Note: The CLI mode changes to IPv4-Access-List Config mode when you successfully execute this
command .
ip access-list name
Format
Mode Global Config
no ip access-list
This command deletes the IP ACL identified by
no ip access-list name
Format
Mode Global Config

ip access-list rename

This command changes the name of an IP Access Control List (ACL) . The
of an existing IP ACL . The
uniquely identifying the IP access list .
This command fails if an IP ACL by the name
ip access-list rename name newname
Format
Mode Global Config
Ubiquiti Networks, Inc.
Table 14. ACL Command Parameters (Continued)
Allows imposing time limitation on the ACL rule as defined by the parameter time-range-name.
If a time range with the specified name does not exist and the ACL containing this ACL rule is applied
to an interface or bound to a VLAN, then the ACL rule is applied immediately. If a time range with
specified name exists and the ACL containing this ACL rule is applied to an interface or bound to a
VLAN, the ACL rule is applied when the time-range with specified name becomes active. The ACL
rule is removed when the time-range with specified name becomes inactive. For information about
configuring time ranges, see "Time Range Commands for Time-Based ACLs" on page 408.
Specifies the assign-queue, which is the queue identifier to which packets matching this rule are
assigned.
Specifies the mirror or redirect interface which is the slot/port to which packets matching this rule are
copied or forwarded, respectively.
Specifies the allowed rate of traffic as per the configured rate in kbps, and
name
newname
parameter is a case-sensitive alphanumeric string from 1 to 31 characters
newname
name
parameter is a case-sensitive alphanumeric string
from the system .
name
already exists .
Quality of Service Commands
burst-size
in kbytes.
parameter specifies the names
396