Snmp-Server Enable Traps Linkmode; Snmp-Server Enable Traps Multiusers; Snmp-Server Enable Traps Stpmode - Ubiquiti EDGESWITCH ES-24-250W Command Reference Manual

EdgeSwitch CLI Command Reference
no snmp trap link-status all
This command disables link status traps for all interfaces .
Note: This command is valid only when the Link Up/Down Flag is enabled .
no snmp trap link-status all
Format
Mode Global Config

snmp-server enable traps linkmode

Note: This command may not be available on all platforms .
This command enables Link Up/Down traps for the entire switch . When enabled, link traps are sent only if the
Link Trap flag setting associated with the port is enabled . See "show snmp" on page 79 .
Default enabled
snmp-server enable traps linkmode
Format
Mode Global Config
no snmp-server enable traps linkmode
This command disables Link Up/Down traps for the entire switch .
no snmp-server enable traps linkmode
Format
Mode Global Config

snmp-server enable traps multiusers

This command enables Multiple User traps . When the traps are enabled, a Multiple User Trap is sent when a user
logs in to the terminal interface (EIA 232 or Telnet) and there is an existing terminal interface session .
Default enabled
snmp-server enable traps multiusers
Format
Mode Global Config
no snmp-server enable traps multiusers
This command disables Multiple User traps .
no snmp-server enable traps multiusers
Format
Mode Global Config

snmp-server enable traps stpmode

This command enables the sending of new root traps and topology change notification traps .
Default enabled
snmp-server enable traps stpmode
Format
Mode Global Config
no snmp-server enable traps stpmode
This command disables the sending of new root traps and topology change notification traps .
no snmp-server enable traps stpmode
Format
Mode Global Config
Ubiquiti Networks, Inc.
Management Commands
74