Set Interface Ppp - Avaya P333R User Manual

Chapter 5 CLI – Layer 2

set interface ppp

Use the set interface ppp command to configure the P330 PPP interface IP
parameters, exit modem mode, disconnect the PPP session, or reset the connected
modem.
A PPP connection can be established only after the P330 is configured with an IP
address and net-mask. The IP address is a dummy address that is shared between
two peers, and must be taken from a subnet that is different from the agent's IP sub-
net.
The syntax for this command is:
set interface ppp <ip_addr><net-mask>
ip_addr
net-mask
Output Example:
P330-N> set interface ppp 149.49.34.125 255.255.255.0
Interface ppp has its ip address set
You can also use the set interface ppp command to enter modem mode, enter
terminal mode, disconnect the PPP session or to reset the connected modem.
The syntax for this command is:
set interface ppp {enable|enable-always|disable|off|reset}
enable
enable-always
disable
off
reset
Output Example:
P330-N> set interface ppp reset
PPP has reset the connected modem.
94
IP address used by the P330 to connect via its PPP interface
Subnet mask used by the P330 to connect via its PPP interface
Enable PPP and enter modem mode.
Enable automatic reentry into modem mode after modem cable
disconnection or reconnection.
Disable PPP and enter terminal mode
Disconnect the active PPP session.
Reset the connected modem.
Avaya P333T-PWR User's Guide