Table of Contents
Advertisement
Chapter 7
Establishing Switch Access
Establishing a PPP via Modem Connection with the P460 (Sideband)
Overview
The Point-to-Point Protocol (PPP) provides a Layer 2 method for transporting multi-
protocol datagrams over point-to-point links. Here only IP datagrams will be
exchanged, over a RS232 serial connection, between the P460 supervisor module
and a remote peer (such as Ethernet) via a modem and the telephone lines. This
provides remote access the sideband management interface of a P460 via a modem.
Sideband (PPP) Interface CLI Commands
In order to...
Configure the device ppp interface
and control a PPP session
Configure the shared secret used in
PPP sessions with CHAP
authentication
Set the time after which the system
automatically disconnects an idle
PPP incoming session
Define the PPP authentication
method
Set the baud rate used in PPP
sessions
Display the PPP parameters of the
active PPP session.
Display the authentication method
used for PPP sessions
Display the time after which the
system automatically disconnects
an idle PPP incoming session
Display the baud rate used in PPP
sessions
Display the ppp configuration
46
Use the following command...
set interface ppp
set ppp chap-secret
set ppp incoming timeout
set ppp authentication incoming
set ppp baud-rate
show ppp session
show ppp authentication
show ppp incoming timeout
show ppp baud-rate
show ppp configuration
Avaya P460 Installation and Maintenance Guide
Advertisement
Table of Contents
