Scpi Programming - Measure V And I, And Dvm Input - Keithley 2302 Instruction Manual

SCPI programming — measure V and I, and DVM input
The commands to measure output voltage and current, and the DVM input are summarized
in Table 2-4
examples" at the end of this section demonstrates how to use these commands.
Table 2-4
SCPI commands — measure V and I, and DVM input
Commands
SENSe[1]
:FUNCtion <name>
:NPLCycles <n>
:AVERage <NRf>
SENSe2
:FUNCtion <name>
:NPLCycles <n>
:AVERage <NRf>
READ[1]?
READ[1]:ARRay?
READ2?
READ2:ARRay?
1
This command applies to the currently selected function.
NOTE
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
(a listing following the table contains specific command notes). The "Programming
Description
SENSe[1] subsystem for Channel #1 (battery channel):
Select readback function: "VOLTage",
"CURRent", or "DVMeter".
Set integration rate (in line cycles) for voltage,
current, and DVM measurements: 0.01 to 10.
Specify the average count for voltage, current,
and DVM measurements: 1 to 10.
SENSe2 subsystem for Channel #2 (charger channel):
Select readback function: "VOLTage",
"CURRent", or "DVMeter".
Set integration rate (in line cycles) for voltage,
current, and DVM measurements: 0.01 to 10.
Specify the average count for voltage, current,
and DVM measurements: 1 to 10.
Trigger and return one reading for Channel #1 (battery
channel)
Trigger an array of readings and return them for
Channel #1 (battery channel)
Trigger and return one reading for Channel #2 (charger
channel)
Trigger an array of readings and return them for
Channel #2 (charger channel)
Refer to the Programming syntax paragraph of Section 6 for a description of
parameters (e.g., <b>, <NRf>, etc.).
Basic Power Supply Operation
1
.
1
.
1
.
1
.
2-17
Default
VOLT
1.0
1
VOLT
1.0
1