Command Notes (Scpi Commands - System) - Keithley 2302 Instruction Manual

11-8 DISPlay, FORMat, and SYSTem
Command notes (SCPI commands — system)
SYSTem:POSetup <name>
Parameters
With RST selected, the power supply powers up to the *RST default conditions. Default
conditions are listed in the SCPI tables.
NOTE
With SAV0-4 specified, the power supply powers-on to the setup that is saved in the specified
memory location using the *SAV command
with the output OFF.
SYSTem:AZERo:STATe <b>
This command enables (ON) or disables (OFF) auto zero, which is normally part of the
measurement process used to null internal offsets. Turning off auto zero increases measurement
speed but at the expense of accuracy. To minimize drift when operating with auto zero off for
extended periods, briefly turn on auto zero periodically.
SYSTem:MEP[:STATe] <b>
This command selects the 488.1 (OFF) or SCPI (ON) GPIB protocol. The 488.1 protocol can
be used to speed up operation over the GPIB. See
SYSTem:TRIGger:TALK:BOTH <b>
This command enables and disables 2-reading trigger on talk. See
SYSTem:TRIGger:CONTinuous <b>
This command enables and disables the trigger continuous mode. See
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
<name> = RST
SAV0
SAV1
SAV2
SAV3
SAV4
The Model 2306-PJ, 2306-VS, and 2302-PJ have only SAV0-SAV2 memory locations.
Program power-on defaults
Power-up to *RST defaults
Power-up to setup stored in memory location 0
Power-up to setup stored in memory location 1
Power-up to setup stored in memory location 2
Power-up to setup stored in memory location 3
Power-up to setup stored in memory location 4
(Section 9). Note that the instrument will power up
Enable or disable auto zero.
Select GPIB protocol.
Appendix for details.
Enable/disable 2-reading trigger on talk.
Enable/disable trigger continuous mode.
Appendix for details.
Appendix for details.