Keithley 2302 Instruction Manual page 110

4-14 Long Integration Measurements
Table 4-2
SCPI commands — long integration measurements (cont.)
Command
:SENSe[1]
:LINTegration
:TLEVel <NRf>
:RANGe <NRf>
:MILLiamp <NRf>
:TEDGe <name>
:TimeOUT <NRf>
:SEARch <b>
:FAST <b>
:DETect <b>
:SENSe2
:FUNCtion "LINTegration"
:LINTegration
:TIME <NRf>
:AUTO
:TLEVel <NRf>
:TEDGe <name>
:TimeOUT <NRf>
:SEARch <b>
:FAST <b>
:DETect <b>
READ[1]?
READ2?
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
Description
Model 2306-PJ when on 500mA current range. Set
trigger level range (10mA, 100mA, or
500mA). The parameter <NRf> sent with this
command causes the trigger to be set with the
trigger level setting of HALFamp, HUNDred,
or TEN. Queries receive responses of 0.5, 0.1,
or 0.01 accordingly. For example, if a value of
75mA is sent with the command, a value of
0.1A will be returned as a response to a query.
Select trigger edge to initiate the measurement:
RISING, FALLING, or NEITHER.
Specify length of timeout: 1–63 (sec).
Enable or disable pulse search.
Enable or disable long integrations fast
readings.
Enable or disable pulse detection mode.
SENSe subystem for channel #2 (charger channel):
Select long integration measurement function.
Long integration configuration:
Set integration time (in sec): X to 60 (where X
is 0.850 for 60Hz, or 0.840 for 50Hz).
Integration time set automatically.
Set trigger level in amps: 0–5 (5mA resolution).
Select trigger edge to initiate the measurement:
RISING, FALLING, or NEITHER.
Specify length of timeout: 1–63 (sec).
Enable or disable pulse search.
Enable or disable long integrations fast
readings.
Enable or disable pulse detection mode.
Trigger and return one reading for battery channel (#1).
Trigger and return one reading for charger channel (#2).
Default
RISING
16
ON
OFF
OFF
VOLT
1
0.0
RISING
16
ON
OFF
OFF