3.
Table 1-1
Display samples
Display mode
Actual V and I:
DVM input:
Pulse current:
Long integration: LONG INT
NOTES
Default settings
The power supply can be set to power-on with the factory default conditions (RST defaults)
or to user-saved setup conditions. The factory default conditions are listed in
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
With the desired mode and active channel displayed, press ENTER. Now the display will
reflect this desired mode and active channel. Note that after selecting PULSE
CURRENT, use the
or
pulse low, or pulse average. Examples of the display modes are shown as follows:
Samples for Channel #1
(Battery)
6.116 V
1.2058 A
DVM INPUT #1 OFF
4.993 V
PULSE HI
2.1947 A
PULSE LO
0.2147 A
PULSE AVG #1 ON
1.1495 A
1.0236 A
"#1" or "#2" indicates present active channel. "ON" indicates that the output is turned
on. With the output turned off, "OFF" is displayed. See Section 2 for details on output-
ting current and voltage.
"NO PULSE" is displayed if the output is OFF or pulses are not detected (output ON)
for pulse current and long integration display modes only.
When a change is made that affects the readings being taken, dashes are displayed
instead of readings. The dashes remain until a valid reading for the new condition is
taken.
key to select the desired pulse measurement: pulse high,
Samples for Channel #2
(Charger)
#1 ON
6.116 V
1.2058 A
DVM INPUT #2 OFF
4.993 V
#1 ON
PULSE HI
2.1947 A
#1 ON
PULSE LO
0.2147 A
PULSE AVG #2 ON
1.1495 A
#1 ON
LONG INT
1.0236 A
Getting Started
Reference
Section 2
#2 ON
Section 2
Section 3
#2 ON
#2 ON
Section 4
#2 ON
Table
1-2.
1-11