Keithley 2302 Instruction Manual page 212

12-14 SCPI Tables
Table 12-4 (cont.)
SENSe command summary (refer to Tables 2-3, 3-2, and 4-2) (cont.)
Command
:SENSe2
:PCURrent
:TIME
:DIGitize?
:SYNChronize
[:STATe] <b>
[:STATe]?
:DELay <NRf>
:DELay?
:TLEVel <NRf>
:TLEVel?
:FAST <b>
:FAST?
:SEARch <b>
:SEARch?
:DETect <b>
:DETect?
:TimeOUT <NRf>
:TimeOUT?
:LINTegration
:TEDGe <name>
:TEDGe?
:TIME <NRf>
:TIME?
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
Description
Query integration time for digitizing or burst
measurements.
Path for pulse detection triggering:
Send ON to select pulse current measurements, or
OFF to select pulse current digitization.
Query pulse current synchronization selection.
Specify trigger delay in seconds (dependent on
SYNC:STAT):
pulse-current measurements: 0 to 0.1 (sync ON)
pulse current digitization: 0 to 5 (sync OFF)
Query specified trigger delay (dependent on
SYNC:STAT).
Set trigger level value 0–5A.
Query trigger level setting.
Enable or disable pulse current fast readings.
Query pulse current fast reading setting.
Enable or disable pulse current search.
Query pulse current search setting.
Enable or disable pulse current detection mode.
Query pulse current detection mode setting.
Specify length of timeout: 5ms - 32s incrementing in
1ms.
Query pulse current timeout setting.
Path to configure long integration measurements (refer to
Section 4):
Set trigger edge to start long integration measurement
(RISING, FALLING, NEITHER).
Query trigger edge setting.
Set integration time in seconds: X to 60 where X is 0.850
for 60Hz or 0.840 for 50Hz).
Query integrations time.
Default
SCPI
parameter
ON
0
0
OFF
ON
OFF
1 (sec)
RISING
1.00