Keithley 2302 Instruction Manual page 210

12-12 SCPI Tables
Table 12-4 (cont.)
SENSe command summary (refer to Tables 2-3, 3-2, and 4-2) (cont.)
Command
:SENSe[1]
:PCURrent
:LINTegration
:TEN?
:RANGe <NRf>
:RANGe?
:MILLiamp
<NRf>
:MILLiamp?
:TimeOUT <NRf>
:TimeOUT?
:SEARch <b>
:SEARch?
:FAST <b>
:FAST?
:DETect <b>
:DETect?
:SENSe2
:FUNCtion <name>
:FUNCtion?
:NPLCycles <n>
:NPLCycles?
:AVERage <NRf>
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
Description
Model 2306-PJ only — Query the 10mA trigger level
setting on the 500mA current range.
Select trigger level range (100mA, 1A, 5A) for the 5A
current range based on <NRf> which causes AMP,
ONE, or MILL setting to be used for trigger level.
Query trigger level range for the 5A current range.
Model 2306-PJ only — when on 500mA current
range. The parameter <NRf> sent with this
command causes the trigger to be set with the
trigger level setting of HALFamp, HUNDred, or
TEN.
Model 2306-PJ only — Query the trigger level
setting on the 500mA current range. Receives
responses in amps of 0.5, 0.1, or 0.01,
accordingly.
Specify length of timeout: 1 to 63 (seconds).
Query timeout.
Enable or disable pulse search.
Query state of pulse search.
Enable or disable long integration fast readings mode.
Query long integration fast readings mode.
Enable or disable long integration detect pulse only
mode.
Query detect mode.
SENSe subsystem for channel #2 (charger channel).
Select measurement function ("VOLTage," "CURRent,"
"DVMeter", "PCURrent," or "LINTegration").
Query measurement function.
Specify integration rate (in line cycles) for voltage, current,
and DVM measurements (0.01 to 10).
Query integration rate.
Specify the average count for voltage, current, and DVM
measurements (1 to 10).
Default
SCPI
parameter
5.0
16
ON
OFF
OFF
VOLT
1
1