Keithley 2302 Instruction Manual page 27

Figure 1-2
Model 2306-VS dual channel battery/charger simulator
POWER
A) Front Panel
B) Rear Panel
NOTE
Make sure that the maximum combined channel output is not exceeded (see Specifications in
Appendix A). Also, do not exceed 3A when using the power supply as a sink. For output volt-
ages exceeding 5V, the maximum sink current is less than 3A (derate the maximum sink current
0.2A for each volt over 5V).
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
2306-VS DUAL CHANNEL BATTERY/CHARGER SIMULATOR
DISPLAY
WARNING:
NO INTERNAL OPERATOR SERVICABLE PARTS,SERVICE BY QUALIFIED PERSONNEL ONLY.
OUTPUT #1
SOURCE SENSE
+ _
+ +
IN
CHANNEL 1
MADE IN
U.S.A.
CAUTION:
FOR CONTINUED PROTECTION AGAINST FIRE HAZARD,REPLACE FUSE WITH SAME TYPE AND RATING.
The output from each channel is isolated from the other channel.
LOCAL
MENU
ENTER
ISOLATION FROM EARTH: 22 VOLTS MAX.
OUTPUT #2
DVM IN
+30 VDC MAX.
DVM IN SOURCE SENSE
SOURCE
_ _ _ + _
+ + +
TRIGGER
CAT I
OUT IN OUT
CHANNEL 2
LINE FUSE
IEEE-488
SLOWBLOW
2.0A, 250V
LINE RATING
100-120VAC,
200-240VAC
50, 60 HZ
165VA MAX.
Getting Started
OPERATE
SET
SOURCE DVM IN
_ _ _
+
1-5