Gpib Operation - Keithley 2302 Instruction Manual

• Introduction — Describes the IEEE-488 (GPIB) standards used by the power supply.
• GPIB bus connections — Shows how to connect the power supply to the GPIB.
• Primary address — Explains how to check and/or change the primary address for the bus.
• Setting the GPIB timeout for responses — Documents general bus commands to set the
GPIB timeout.
• General bus commands — Documents general bus commands that pertain to all GPIB
instruments.
• Front panel aspects of GPIB operation — Describes aspects of the front panel and remote
panel.
• Programming syntax — Provides syntax information for sending command and SCPI
commands over the bus.
NOTES
This manual covers Keithley Models 2302, 2302-PJ, 2306, 2306-PJ, and 2306-VS
simulators (power supplies). Since the Model 2302 and 2302-PJ are single channel
battery simulators, functions related to the second channel (i.e., the charger channel)
are not available for the Model 2302 and 2302-PJ. Therefore:
• battery and charger channel features contained in this manual apply for the
Models 2306, 2306-VS and 2306-PJ
• only battery channel features contained in this manual apply for the Model 2302
and 2302-PJ
Refer to Appendix F for specific Model 2302 and 2302-PJ information.
Information contained in this section applies to all power supply channels (unless
otherwise noted). In this manual, channel 1 refers to the battery channel while
channel 2 refers to the charger channel (2306, 2306-VS and 2306-PJ feature only).
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com

GPIB Operation

7