Keithley 2302 Instruction Manual page 209

Table 12-4 (cont.)
SENSe command summary (refer to Tables 2-3, 3-2, and 4-2) (cont.)
Command
:SENSe[1]
:PCURrent
:TimeOUT <NRf>
:TimeOUT?
:LINTegration
:TEDGe <name>
:TEDGe?
:TIME <NRf>
:TIME?
:AUTO
:TLEVel
[:AMP] <NRf>
[:AMP]?
:ONE <NRf>
:ONE?
:MILLiamp
<NRf>
:MILLiamp?
:HALFamp
<NRf>
:HALFamp?
:HUNDred
<NRf>
:HUNDred?
:TEN <NRf>
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
Description
Specify length of timeout: 5ms - 32s incrementing in
1ms.
Query pulse current timeout setting.
Path to configure long integration measurements (refer to
Section 4):
Set trigger edge to start long integration measurement
(RISING, FALLING, NEITHER).
Query trigger edge setting.
Set integration time in seconds: X to 60 where X is 0.850
for 60Hz line frequency or 0.840 for 50Hz line
frequency.
Query integration time.
Power supply sets integration time.
Path to set trigger level.
Set trigger level for 5A range: 0 to 5 (amps).
Query trigger level for 5A range.
Set trigger level for 1A range: 0 to 1 (amps).
Query trigger level for 1A range.
Set trigger level for 100mA range: 0 to 0.1 (amps).
Query trigger level for 100mA range.
Model 2306-PJ only — Set trigger level (in amps) for
500mA range on 500mA current range: 0-500mA
Model 2306-PJ only — Query the 500mA trigger
level setting on the 500mA current range.
Model 2306-PJ only — Set trigger level (in amps) for
100mA range on 500mA current range: 0-100mA
Model 2306-PJ only — Query the 100mA trigger
level setting on the 500mA current range.
Model 2306-PJ only — Set trigger level (in amps) for
10mA range on 500mA current range: 0-10mA
SCPI Tables 12-11
Default
SCPI
parameter
1 (sec)
RISING
1.00
0
0
0
0.0
0.0
0.0