Keithley 2302 Instruction Manual page 208

12-10 SCPI Tables
Table 12-4 (cont.)
SENSe command summary (refer to Tables 2-3, 3-2, and 4-2) (cont.)
Command
:SENSe[1]
:PCURrent
:SYNChronize
:TLEVel
:RANGe
<NRf>
:RANGe?
:MILLiamp
<NRf>
:MILLiamp?
:DELay <NRf>
:DELay?
:FAST <b>
:FAST?
:SEARch <b>
:SEARch?
:DETect <b>
:DETect?
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
Description
Set trigger level range (100mA, 1A, or 5A) for the
5A current range. The parameter <NRf> sent
with this command causes the trigger to be set
with the trigger level setting of MILL, ONE, or
AMP. Queries receive responses of 0.1, 1.0, or
5.0 accordingly. In other words, if a value of
2.0A is sent with the command, a value of 5A
will be returned as a response to a query.
Query selected trigger level range for the 5A
current range.
Model 2306-PJ only — when on 500mA current
range. The parameter <NRf> sent with this
command causes the trigger to be set with the
trigger level setting of HALFamp, HUNDred,
or TEN.
Model 2306-PJ only — Query the trigger level
setting on the 500mA current range. Receives
responses in amps of 0.5, 0.1, or 0.01,
accordingly.
Specify trigger delay in seconds:
0.0–0.1 (pulse current measurements) or
0.0–5.0 (pulse current digitization).
Query specified trigger delay (dependent on
SYNC:STAT).
Enable or disable pulse current fast readings.
Query pulse current fast reading setting.
Enable or disable pulse current search.
Query pulse current search setting.
Enable or disable pulse current detection mode.
Query pulse current detection mode setting.
Default
SCPI
parameter
5A
0.0
OFF
ON
OFF