Keithley 2302 Instruction Manual page 211

Table 12-4 (cont.)
SENSe command summary (refer to Tables 2-3, 3-2, and 4-2) (cont.)
Command
:SENSe2
:AVERage?
:CURRent [:DC]
:RANGe
[:UPPer] <NRf>
[:UPPer]?
:AUTO <b>
:AUTO?
:PCURrent
:AVERage <NRf>
:AVERage?
:MODE <name>
:MODE?
:TIME
:AUTO
:HIGH <NRf>
:HIGH?
:LOW <NRf>
:LOW?
:AVERage <NRf>
:AVERage?
:DIGitize <NRf>
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
Description
Query average count.
Path to configure the current measurement function:
Current measurement range:
Specify expected current measurement which will
select 5mA or 5A for current range.
Query current measurement range.
Enable or disable auto range.
Query state of auto range.
Path to configure the pulse-current measurement function
(refer to Section 3):
Specify average count (dependent on SYNC:STAT):
pulse-current measurements: 1 to 100 (sync ON)
pulse current digitization: 1 to 5000 (sync OFF)
Query average count (dependent on SYNC:STAT).
Select pulse-current measurement mode (HIGH, LOW,
or AVERage).
Query pulse-current measurement mode.
Path to set pulse-current integration times:
Power supply sets integration times — accounts for
internal trigger delay but not user delay (:DEL).
Specify integration time (in sec) for high pulse
measurements (33.33E-06 to 0.8333) — accounts
neither for internal trigger delay nor user delay.
Query high integration time.
Specify integration time (in sec) for low pulse
measurements (33.33E-06 to 0.8333) — accounts
neither for internal trigger delay nor user delay.
Query low integration time.
Set integration time in seconds for measurement of
pulse AVERage time — accounts neither for
internal trigger delay nor user delay.
Query average integration time.
Specify integration time (in sec) for digitizing or burst
measurements; 33.33e-6 to 0.8333.
SCPI Tables 12-13
Default
SCPI
parameter
5.0
OFF
1
HIGH
3.333E-05
3.333E-05
3.333E-05
3.333e-5