Trigger On Talk Both Channels; Bus Commands - Keithley 2302 Instruction Manual

Trigger on talk both channels

NOTE
Trigger on talk will return a reading for the active channel (DISPlay:CHANnel?) unless you
have enabled (ON) the setting for Trig on talk to return two readings—one from each channel
comma delimited (for example: ch1 reading, ch2 reading). This command maps trigger on talk
to BOTHREAD? when enabled.
To enable the two readings trig on talk and have it apply to both channels (READ1? for
channel 1, READ 2? for channel 2), send:
SYSTem:TRIGger:TALK:BOTH ON
To disable the two readings trig on talk, send:
SYSTem:TRIGger:TALK:BOTH OFF

Bus commands

Table G-1
Table G-1
Trigger on talk bus commands
Commands
:SYSTem
:TRIGger
:TALK
:BOTH <b>
:BOTH?
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
This command applies only to Models 2306, 2306-VS and 2306-PJ.
contains bus commands for trigger on talk,
Description
Path to System commands.
Path to trigger commands.
Path to talk commands.
Set <b> to 1 (or ON) to enable 2 reading trig on talk. 0 (or OFF)
disable 2 reading trig on talk, but reads the active channel:
CH1: READ1?
CH2: READ2?
Query trigger on talk.
488.1 Protocol G-5
Default
OFF