Dtc (Diagnostic Trouble Code) Output; Use Of Mode Select Switch - Suzuki GSX650FA Service Manual

4E-12 ABS:

DTC (Diagnostic Trouble Code) Output

(GSX650FAK9)
NOTE
• Even through the ABS is operating
correctly, a DTC is memorized in any of the
following conditions.
– If the motorcycle is put on its
centerstand, the engine is started and
only the rear wheel is rotated.
– Previous malfunctions were repaired,
but the DTCs were not deleted.
• After carrying out DTC deleting and ABS
operation check, explain to the customer
that the ABS is operating correctly. Refer
to "DTC (Diagnostic Trouble Code)
Deleting in related manual".

Use of Mode Select Switch

Connect the special tool to the mode select coupler to
output the memorized DTCs on the ABS indicator light.
1) Turn the ignition switch OFF.
2) Remove the left frame cover. Refer to "Exterior Parts
Removal and Installation (GSF650/S/A/SAK7) in
Section 9D in related manual".
3) Connect the special tool to the mode select coupler
(1) (O – B/W).
Special tool
(A): 09930–82710 (Mode select switch)
(A)
B917H24504028
1
I917H2450015-01
I917H2450004-01
4) Switch the special tool to ON.
5) Turn the ignition switch ON.
The ABS indicator light (2) starts flashing to indicate
the DTC. Refer to "DTC Table in related manual".
NOTE
• If there is a DTC, the ABS indicator light
keeps flashing cyclically and repeatedly.
• If there is no DTC, the ABS indicator light
keeps lighting on.
• If the DTCs are to be output for a long time,
remove the HEAD-LO fuse in order to
prevent the battery from discharging.
FI
2
6) Turn the ignition switch OFF and disconnect the
special tool.
I718H1450040-02
I917H2450016-01