Flywheel - TOHATSU NB-1000 Service Manual

SECTION 4
19
Installation
1. Position recoil starter on powerhead and install mounting bolts.
2. Make sure engine is in NEUTRAL. Install the start-in-gear
19
protection mechanism (1) , (2) , (3) and (4).
3. Test the operation of the start-in-gear protection mechanism.
start-in-gear protection mechanism must be
installed. NEVER return engine to customer with
mechanism disconnected or not functioning
properly.

FLYWHEEL

Flywheel magneto must be of a particular strength in
order to run the ignition system. Flywheels seldom
go bad and would only be replaced as a last resort in
solving an ignition problem.
Flywheel is under high torque and requires the
use of special tools for removal and installation.
Failure to use the specified tools can result in
injury or damage to the flywheel or coil plate
electrical components.
4-20
WARNING
NOTE
CAUTION
1-/ 2-Cylinder