TOHATSU NB-1000 Service Manual page 247

11. Connect RED tester lead to connector closest to fuse holder (12).
If meter does not indicate battery voltage, find source of overload
or short and replace 15 A engine fuse (13). Possible sources of
short or overload:
• Short in starter circuit wiring or components, such as starter
solenoid, main key switch, or neutral start switch.
• Short in charging circuit wiring or components, such as the
alternator coils or rectifier/regulator.
• Short in accessories.
• Short in starter motor.
If meter indicates battery voltage, go to next step.
12. Connect RED tester lead to connector closest to main key
switch (14).
For models with remote control box - Make sure you
test the correct terminal in this step. Terminal (14) is
connected directly to the main key switch (10) and
the RED lead that comes out of the large cable (15)
that connects the engine compartment (16) to the
remote control box (17), DO NOT CONFUSE
TERMINAL (14) WITH TERMINAL (18).
For models without remote control box - You might
have to pull connector (15) apart and measure voltage
at terminal.
Make sure you test the correct terminal in this step.
If meter does not indicate battery voltage, repair or replace cable
between (12) and (14).
If meter indicates battery voltage, go to next step.
13. Connect RED tester lead to main key switch lead (19) and turn
main key switch (10) to START position.
1-/ 2-Cylinder
NOTE
NOTE
ELECTRICAL SYSTEM
7-55