TOHATSU NB-1000 Service Manual page 126

SECTION 5
1 2 3 4
bent, or wom:
• Steering handle (7)
• Steering bracket (8)
7. Inspect throttle cables (3) for kinks, wear, cracks in
1 2
the protective covering, and excessive stretch.
Assembly
3 4
2
Apply genuine grease or equivalent friction surface
marine grease to bushings (9), spacer (11), and the
grip portion of steering handle (7) before assembly.
DO NOT lubricate friction piece (5).
1. Apply spray lubricant to the throttle cables. Work the cables back
and forth to ensure full coverage under the protective covering.
2. Assemble aIl components onto throttle shaft
2 3 4
(4) and connect throttle cables (3) to throttle
shaft as required. Route opposite end of throttle cables through
steering handle (7).
3. Install throttle shaft in steering handle.
7
For the 9.9/15/18/25/30 and 40 models, make sure
the throttle shaft is positioned (1) as shown during
installation.
3 4
1 2
5. Fully assemble all remaining components as iIIustrated.
5-8
6. Verify the following components and
their friction surfaces are not cracked,
NOTE
NOTE
4. lnstall grip (2).
5
T1650
1-/ 2-Cylinder