4. Turn the throttle grip toward SLOW side.
7
5. Adjust the stopper bolt (for full close adjustment) so that it hits
the stopper bolt at the position where the magneto coil plate timing
mark (fully closed side) meets the ignition timing inspection line
(crank case mating surface).
After making adjustments, check that the advancer
arm moves firmly and smoothly. Tighten adjusting
nut after completing adjustments.
6. At the neutral and reverse position, the starter lock arm
8
and neutral stop arm controls the engine speed.
1-/ 2-Cylinder
GENERAL SERVICE INFORMATION
CAUTION
T1974
T1975
2-35