TOHATSU NB-1000 Service Manual page 219

1. Remove negative lead from battery.
2. Disconnect emergency stop switch terminals (1), (2), (3)
6
and (4).
3. Set analog multimeter to check continuity. Connect one
6
meter lead to terminal (1) and the other to terminal (3).
4. Attach lanyard (5) to emergency stop switch (6), meter
6
must not show continuity. lf it does, replace emergency stop
switch.
5. Remove lanyard (5) from emergency stop switch (6),
6
meter must show continuity. lf not, replace emergency stop
switch.
6. Disconnect CD Unit (9) terminals (7) and (8).
6
7. Connect one meter lead to terminal (8) and the other to
6
terminal (2) and check continuity. lf the meter does not show
continuity, replace the cable.
8. Connect one meter lead to terminal (8) and the other to a
6
clean engine ground. lf the meter shows continuity, replace
the cable.
9. Reconnect aIl wires and return to -Test 2 - Stop Circuit Test flow
chart.
6
1-/ 2-Cylinder
ELECTRICAL SYSTEM
T1476
7-27