TOHATSU NB-1000 Service Manual page 72

15
lnstallation
1. Check that the round boss on the carburetor mates with
14
the hole in the clamp.
2. Position the carburetor on the crankcase inlet and push
15
until fully seated. Make sure that the carburetor is vertical.
Tighten clamp securely.
16
3. Install carburetor cover (2).
16
4. Attach fuel hose (1).
5. Install motor cover and open fuel cock.
Adiustments
An access hole in the motor cover allows idle
adjustment with the motor cover on.
1. IDLE – With the throttle in the START position, turn the
17
slow stop screw aIl the way in, then back-out l-1/4 turns.
Start the engine and after warm-up, move the throttle all the way
down to the idle position. Turn the stop screw clockwise to
increase RPM, or counterclockwise to decrease RPM.
1-/ 2-Cylinder
14
T1135
NOTE
FUEL SYSTEM
T1155
T1124
T1156
3-25