TOHATSU NB-1000 Service Manual page 75

SECTION 3
7. Remove any serviceable plugs (11) and jets (12). Typical
8
carburetor shown.
Cleaning
DO NOT clean carburetor by submerging or
soaking in a hot tank or carburetor dip cleaner.
DO NOT expose plastic parts to carburetor
cleaner.
1. Clean aIl metal components using a mild aerosol solvent
9
or isopropyl alcohol. Use a soft bristle brush to remove
gummy deposits.
2. Clean plastic parts with warm soapy water.
3. Dry all components with low pressure compressed air. When drying
passages, direct the flow of air opposite the direction of fuel flow.
4. Inspect the carburetors, this section.
3-28
CAUTION
8
T1144
T1145
1-/ 2-Cylinder