TOHATSU NB-1000 Service Manual page 185

lnstallation
Ignition system must be disabled to prevent
accidental engine start-up during installation of
the gearcase.
1. Lightly coat the driveshaft splines with genuine engine oil or
43
TC-W3 oil and apply silicone spray lubricant to water pipe
lower seal (1).
2. Slide driveshaft into lower crankcase head. Align water pipe
44
with lower seal (2) before seating gearcase on driveshaft
housing.
3. Apply Loctite 242 to threaded portion of gearcase mounting
45
bolts. Install the gearcase mounting bolts (3) and torque all
bolts to specification.
4. lnspect trim tab (5) and replace if corroded. Install trim tab
46
packing (4) and trim tab (5).
5. Use spring pin tool B (6) (Part No. 345-72228-0) to install
47
new upper spring pin in shift rod joint. DO NOT reuse the old
spring pin.
1-/ 2-Cylinder
T1417
WARNING
GEARCASE
T1748
45
46
T1750
T1751
T1749
6-33