TOHATSU NB-1000 Service Manual page 225

11
11
- Models 9.9 / 15 / 18 / 25 / 30 and 40
The pulser coil test is used to determine the output
10 11
voltage, in DVA, from the pulser coil (1), located on
the coil plate assembly (2), to the CD Unit (3) while
you are cranking the engine.
1. Disconnect the following terminals:
Engine Models
5
9.9 / 15 / 18 / 25 / 30 / 40
2. Set the digital multimeter to ohms and connect the leads to test
the resistance of the pulser coil
Engine Models
5
9.9 / 15 / 18 / 25 / 30 / 40
1-/ 2-Cylinder
ELECTRICAL SYSTEM
Disconnect Terminals
4,5,6 and 7
4, 5, 6, 7, 8 and 9
Connect Multimeter
Between These Terminals
• 4 and 6
• 6 and 8
T1991
7-33