TOHATSU NB-1000 Service Manual page 236

SECTION 7
Cleaning and Inspection
Clean coil plate assembly, upper main bearing seal (1), set
8
ring, ignition timing link, alternator coils, pulser coils, coil
leads, and coil connectors with isopropyl alcohol as required.
Check for the following and repair or replace as required:
• Bent, chipped, cracked, or corroded coil plate assembly.
• Coil leads for integrity, cut or cracked insulation, and damaged
connectors.
• Broken or bent alternator coil Laminations damaged alternator
coil windings and missing alternator coil screws.
• Broken, cracked, or misaligned pulser coils and missing pulser
coil screws.
• Free motion of ignition timing link (1). Repair, adjust, and
9
lubricate as needed, see Section 2.
Installation
Install in reverse order of removal.
Use threadlocker on screw threads before installing
screws.
Use a length of shrink tube to fabricate a new coil
plate assembly cable shield as required. Inside
diameter of shrink tubing must be large enough to
pass over the largest connector.
7-44
NOTE
T1996
T1786
1-/ 2-Cylinder