TOHATSU NB-1000 Service Manual page 71

SECTION 3
4. Install float chamber. Use Loctite 242 on screw threads and
tighten securely.
9
5. Install drain screw (4) and new gasket.
9
6. Install throttle stop screw and spring (13).
7. lf removed, install choke assembly. Use a drift to peen end
10
of shaft screw to prevent nut from coming loose.
8. If disassembled, assemble the throttle assembly.
9. Align the groove in the slide with the pin (A) in the
11 12
slide LE bore. Carefully install slide and tighten cap (6)
securely using fingers.
13
10. Install new o-ring.
11. Install clamp, but do not tighten.
3-24
T1133 T1134
12
T1126
T1128
1-/ 2-Cylinder