TOHATSU NB-1000 Service Manual page 178

SECTION 6
13. lnstall clutch push rod (19) so tapered end faces bevel
26
gearA.
14. Compress the clutch spring by applying pressure to
27
push rod (19). Align the holes of the clutch and spring holder
and insert clutch pin (20).
Wear safety glasses and DO NOT hold spring end
of propeller shaft towards face or body when
compressing the clutch spring.
15. lnstall new clutch pin snap spring (21) using the clutch
28
pin snap tool. Do not reuse old snap Spring.
Part number of clutch pin snap tool
9.9/15/18 : 350-72229-0
25/30 : 346-72229-0
40 : 345-72229-0
DO NOT reuse clutch pin snap spring (21), it must
be replaced. Reusing clutch pin snap spring may
cause severe damage to gears and other
components.
16. Make sure aIl necessary adjustment shims are installed on
29
bevel gear C (22) and install gear onto propeller shaft housing
(23). Install washer (24) onto bevel gear.
17. Apply genuine grease or equivalent to the propeller shaft
30
housing o-ring and oil seal. Slide the propeller shaft into the
propeller shaft housing.
18. Lift the cam rod to the fully UP position and verify through
31
the gearcase opening that clutch cam beveled side (25) faces
gearcase opening.
6-26
T2045
CAUTION
CAUTION
T1739 T1740
T1741
T1398
T2046
1-/ 2-Cylinder