TOHATSU NB-1000 Service Manual page 250

SECTION 7
8
4. Remove pinion gear (3), spring (4) and pinion collar
8 9
(5).
5. Clean removed components with cleaning solvent and examine pinion
gear for wear and chipped teeth and spring for tension or distortion
and replace assembly as required.
Do not allow cleaning solvent to come in contact with
starter motor.
6. Apply a light coat of low temperature lithium grease to motor shaft
(7) and slide on pinion gear (3), wind counterclockwise to seat.
7. Slide spring (4) and pinion collar (5) on motor shaft (7).
10
8. Push down on pinion collar (2) and install locking ring (1).
11
9. Tap pinion collar (1) in place.
Disassemble Starter Motor
Bolts for models 25 / 30 /40 may not be available as
separate parts. Check current Parts Catalog for
availability.
9 12
1. Remove bolts (1).
2. Remove motor base (2).
7-58
9
T1793
NOTE
NOTE
T1794
12
T1523
T1525
T1793
1-/ 2-Cylinder