TOHATSU NB-1000 Service Manual page 172

SECTION 6
9
8. Lift the driveshaft from the gearcase and set it aside.
9. Reach inside gearcase and remove roller bearing (8) and
10
bevel gear A (9).
Taper bearing for bevel gear A is only used on Model
40.
10. Remove the stopper and lift cam rod (10) from gearcase.
11
Fullydisassemble the cam rod components, including the
cam rod bushing internal and external o-rings.
11. Remove clutch push rod (11) and ball (12) from
12
propeller shaft. Pull propeller shaft out of housing.
12. Remove washer (13), bevel gear A (14), and all shims (15)
13
(25/30 and 40) from propeller shaft.
6-20
T1372
NOTE
T1726 T1727
T1728
T1729
1-/ 2-Cylinder