TOHATSU NB-1000 Service Manual page 239

3. Remove the screws (1) and remove coil plate assembly (2)
13
from the set ring.
Cleaning and Inspection
Clean upper main bearing seal (1), guide plate (2) and
14 15
set ring (3) with dry cloth.
Check for the following and repair or replace as required:
• Bent, chipped, cracked, or corroded guide plate.
• Broken or bent set ring.
Apply light coat of Iow temperature lithium grease to guide plate (2).
Istallation
Install in reverse order of removal.
Disconnect negative battery cable from battery
before installing coil plate assembly.
Use threadlocker on screw threads before installing
screws.
Apply light coat of low temperature lithium grease to
the guide plate.
Ignition Coil
Disconnect negative battery cable from battery
before removing ignition coil.
1-/ 2-Cylinder
NOTE
NOTE
ELECTRICAL SYSTEM
T1999
T2000
T2001
7-47