TOHATSU NB-1000 Service Manual page 8

SECTION 1
8. Keep all removed parts separated for ease of identification during
assembly.
9. Locate alignment marks on components being disassembled. If
marks are not present and should be, scribe or match mark them
yourself to ensure the pieces are assembled properly.
10. Follow torque sequences and specifications where they apply.
First, tighten each bolt in the specified sequence. Use the same
sequence to torque each bolt to final specification. Special torque
specifications are listed at the beginning of each section. Standard
torque specifications for common fasteners are listed in Section 3.
11. Use lubricant when assembling seals to prevent damage to the
seal lips. Make sure seal lips are facing the correct direction.
12. Use the correct type and amount of sealing compound on metal
to metal surfaces.
13. When using compressed air to clean or dry parts, make sure air
supply is regulated not to exceed 25 psi [172 kPa /1.76 kg/cm ].
2
14. Replace missing or damaged safety labels on the engine before
returning it to the customer.
1-6
1-/ 2-Cylinder