TOHATSU NB-1000 Service Manual page 142

SECTION 5
6. Install water pipe (4) in engine base (5) and align for
13
installation in the driveshaft housing.
7. Verify knocks (where used) are installed in driveshaft
14
housing. Apply high temperature gasket dressing to both
sides of new driveshaft housing gasket and install gasket on
housing.
Installation
1. Insert the damper cap (1) and damper collar (2) into the
16
drive shaft housing.
2. Assemble the lower rubber mount components and install them
into the drive shaft housing.
3. Apply Loctite 243 to bolt threads and torque to specification.
4. Install clip.
5. Assemble the upper rubber mount components and install
17
them into the engine base.
6. Apply Loctite 242 to bolt threads, install the retainer and torque
to specification.
7. Install gearcase as described in Section 6.
8. Install lower engine cover, this section.
9. Install tiller steering handle if equipped, this section.
10. lnstall powerhead as described in Section 4.
5-24
T2005
14
16
17
T2006
T1627
T1628
1-/ 2-Cylinder