9.9/15/18 Linkage Adjustment - TOHATSU NB-1000 Service Manual

Installation
1. lnstall the tiller steering assembly.
2 3 4
2. Connct throttle cable(s) (or throttle shaft).
3. Adjust screw (12) by tightening or loosening it to
2 3
obtain proper grip turning resistance.

9.9/15/18 Linkage Adjustment

7
Adjustment of Throttle Mechanism
Item Description
1. Timing Mark
2. Ignition Timing Inspection Line
3. Link Rod 5-65L
4. Link Rod 5-60L
5. Advancer Arm
6. Stopper Bolt (Fully-open)
7. Stopper Bolt (Fully-closed)
8. M8 Nylon Nut
Make this adjustment only after fitting the power
unit to the lower unit.
Apply grease on sliding parts and ball joints of
the advancer arm bushing.
Adjust link rods 5-60L and 5-65L as shown in
figure [8] prior to adjusting ignition timing.
1-/ 2-Cylinder
CAUTION
CAUTION
CAUTION
MIDSECTION
7
T2002
5-9