Windshield Wiper Blade Element; Windshield Wipers And Washer; Windshield Wiper Motor - Chrysler 1998 Voyager Service Manual

8K - 6 WINDSHIELD WIPERS AND WASHERS
REMOVAL AND INSTALLATION (Continued)

WINDSHIELD WIPER BLADE ELEMENT

REMOVAL
(1) Disengage the release tab holding the wiper
blade to the wiper arm and remove the wiper blade
from the wiper arm (Fig. 6).
(2) Disengage clip holding the wiper element to
wiper blade (Fig. 7).
Fig. 7 Windshield Wiper Blade Element
(3) Pull the element from the claws on the wiper
blade.
INSTALLATION
(1) Insert the element vertebra (Fig. 8) into claw
at the open end of the wiper blade and through each
claw location along the blade.
Fig. 8 Wiper Blade and Element
(2) Engage clip to hold wiper element to wiper
blade.
(3) Test wiper effectiveness using washer mode
and align if necessary.

WINDSHIELD WIPER MOTOR

REMOVAL
(1) Remove wiper unit from vehicle.
(2) Remove wiper linkage and motor mount plate
from wiper unit.
(3) Disconnect wire connectors from back of wiper
motor (Fig. 16).
(4) Remove wiper linkage from motor crank. Do
NOT remove crank from motor.
(5) Remove bolts holding wiper motor to mount
plate and remove motor (Fig. 9) and (Fig. 10).
Fig. 9 Wiper Motor Crank
Fig. 10 Wiper Motor
INSTALLATION
(1) Place wiper unit on a suitable work surface.
(2) Place wiper motor in position on mount plate.
(3) Install bolts to hold wiper motor to mount
plate.
(4) Install wiper linkage and motor mount plate
into wiper unit.
(5) Connect wire connectors to wiper motor (Fig.
16).
(6) Place the wiper unit into engine compartment
and connect wiper unit wire connector to engine wire
harness (Fig. 13).
(7) Operate wiper motor and verify that the wiper
motor parks when wiper switch is turned OFF.
NS